LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1106 (Seat System) >> Repair Instructions >> Head Restraint Retainer Replacement - Rear Seat >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Headrest Retainers
    GM521249Courtesy of GENERAL MOTORS CORP.
  1. Install the guide to the seat back frame, pressing in until fully seated into the rear seat frame.
  2. Install the rear seat cover to the rear seat back.
  3. Install the J-hook retainer at the bottom edge of the rear seat back cover.
  4. Install the headrest to the rear seat. Refer to Head Restraint Replacement - Rear Seat .
  5. Place the rear seat back to the original position.
scientia non olet · About LEMON Manuals