Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Aspirator Hose Mounting Screw

Courtesy of GENERAL MOTORS CORP.

Install the aspirator hose to the HVAC module.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the aspirator hose retaining screw.
Tighten: Tighten the screw 0.9 N.m (8 lb in).
Connect the aspirator hose to the aspirator duct adapter (1).
Install the I/P carrier. Refer to Instrument Panel (I/P) Carrier Replacement in Instrument Panel, Gages and Console.