LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1104 (HVAC Systems - Automatic) >> Repair Instructions >> Air Temperature Actuator Replacement - Right >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of HVAC Module
    GM651483Courtesy of GENERAL MOTORS CORP.
  1. Install the right hand temperature actuator.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the right hand temperature actuator mounting screws.

    Tighten:  Tighten the screws to 1.6 N.m (14 lb in).

    3. Fig 2: Locating Actuator Connector
    GM295297Courtesy of GENERAL MOTORS CORP.
  3. Connect the right hand temperature actuator electrical connector.
    4. IMPORTANT: Align the pin on the right hand air temperature actuator with the slot in the right hand temperature door lever.
    Fig 3: Locating Right Hand Temperature Door Lever Spring
    GM868231Courtesy of GENERAL MOTORS CORP.
  4. Install the right hand temperature lever (1) to the right hand temperature door.
  5. Connect the right hand temperature door lever spring (2) to the right hand temperature door lever (1) and HVAC module case.
  6. Install the I/P compartment. Refer to Compartment Replacement - Instrument Panel (I/P) in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals