LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (Body Rear End) >> Repair Instructions >> Weatherstrip Replacement - Endgate >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the endgate.
  2. Remove the push-in retainers from each end of the endgate weatherstrip, using J 38778  .
  3. Remove the endgate weatherstrip from the endgate starting at the corner of the endgate and pull the weatherstrip from the endgate pinch-weld flange.
    Fig 1: View Of Endgate Weatherstrip In Pinch-Weld Flange
    GM621872Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals