LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (Body Rear End) >> Repair Instructions >> Water Deflector Replacement - Liftgate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the liftgate door water deflector to the liftgate inner panel.
    Fig 1: Identifying Liftgate Water Deflector
    GM823680Courtesy of GENERAL MOTORS CORP.
  2. Secure the water deflector at the corners.
  3. Install the liftgate water deflector, start pressing the adhesive pattern at the bottom center and working outward and upward in order to prevent puckering.
  4. Install the liftgate trim panel. Refer to Trim Panel Replacement - Liftgate (Aztek)  or Trim Panel Replacement - Liftgate (Rendezvous) .
scientia non olet · About LEMON Manuals