LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (Body Rear End) >> Repair Instructions >> Trim Panel Replacement - Liftgate (Aztek) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the liftgate.
  2. Remove the lower liftgate trim panel sides by pulling the left and right sides from the liftgate frame.
    Fig 1: View Of Lower Liftgate Trim Panel (Aztek)
    GM624452Courtesy of GENERAL MOTORS CORP.
  3. Remove the lower liftgate trim panel from the pinch-weld flange by pulling up from the pinch-weld flange.
  4. Remove the lower liftgate trim panel from the vehicle.
  5. Remove the upper liftgate trim panel sides by pulling the left and right sides from the liftgate frame.
    Fig 2: Identifying Upper Liftgate Trim Panel (Aztek)
    GM624443Courtesy of GENERAL MOTORS CORP.
  6. Remove the upper liftgate trim panel from the pinch-weld flange by pulling up from the pinch-weld flange.
  7. Remove the upper liftgate trim panel from the vehicle.
scientia non olet · About LEMON Manuals