LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (Body Rear End) >> Repair Instructions >> Trim Panel Replacement - Endgate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Before installing the endgate trim panel to the endgate inner panel, the old trim panel retainers MUST be discarded and replaced with NEW trim panel retainers.
  1. Install the new trim panel retainers to the endgate trim panel.
  2. Align the endgate trim panel to the endgate inner panel.
    Fig 1: View Of Endgate Trim Panel
    GM620958Courtesy of GENERAL MOTORS CORP.
  3. Install the endgate trim panel by firmly pressing in the area of the retainer clips until the clips are fully seated around the perimeter of the endgate trim panel.
  4. Install the endgate inside handle to the endgate. Refer to Handle Replacement - Endgate .
  5. Close the endgate.
scientia non olet · About LEMON Manuals