LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (Body Rear End) >> Repair Instructions >> Strut Replacement - Liftgate >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.
NOTE: Refer to Liftgate/Hood Assist Rod Notice in Cautions and Notices.
  1. Open and support the liftgate.
  2. Lift up the retainer clips on the assist rods using a small flat-bladed tool.
    Fig 1: Identifying Assist Rod Retainer Clips
    GM621882Courtesy of GENERAL MOTORS CORP.
  3. Remove the upper end of the assist rods from the ball joint.
    Fig 2: View Of Liftgate Struts
    GM621880Courtesy of GENERAL MOTORS CORP.
  4. Remove the lower end of the assist rods from the ball joint.
    Fig 3: View Of Lower End Of Assist Rods
    GM621881Courtesy of GENERAL MOTORS CORP.
  5. Remove the assist rods from the liftgate.
scientia non olet · About LEMON Manuals