LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (Body Rear End) >> Repair Instructions >> Spoiler Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the liftgate trim. Refer to Trim Panel Replacement - Liftgate (Aztek)  or Trim Panel Replacement - Liftgate (Rendezvous) .
  2. Remove the rear liftgate spoiler water channel.
  3. Remove the rear liftgate spoiler nuts.
  4. Using a thin-bladed tool, cut the adhesive tape along the upper edge of the rear spoiler.
    Fig 1: Cutting Adhesive Tape On Upper Rear Spoiler Edge
    GM861397Courtesy of GENERAL MOTORS CORP.
  5. Using a thin-bladed tool, cut the adhesive tape along the lower edge of the rear spoiler.
    Fig 2: Separating Adhesive Tape On Lower Rear Spoiler Edge
    GM861401Courtesy of GENERAL MOTORS CORP.
  6. Remove the rear spoiler from the liftgate.
    Fig 3: View Of Rear Spoiler
    GM861381Courtesy of GENERAL MOTORS CORP.
  7. Clean the vehicle mounting surface and the rear spoiler using Varnish Makers and Painters (VMP) naphtha.
scientia non olet · About LEMON Manuals