LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (Body Rear End) >> Repair Instructions >> Pressure Relief Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the pressure relief valve to the lower quarter panel.
    Fig 1: View Of Pressure Relief Valve
    GM621841Courtesy of GENERAL MOTORS CORP.
  2. Press the pressure relief valve into the quarter lower panel until the retainers lock into place at the upper and lower locations.
  3. Install the rear bumper fascia. Refer to Fascia Replacement - Rear Bumper (Aztek) or Fascia Replacement - Rear Bumper (Rendezvous) in Bumpers.
scientia non olet · About LEMON Manuals