LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (Body Rear End) >> Repair Instructions >> Lock Striker Replacement - Endgate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the endgate strikers and shims to the locations marks.
    Fig 1: View Of Endgate Striker Components
    GM621897Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screws to the endgate strikers.

    Tighten:  Tighten the endgate strikers to 25 N.m (18 lb ft).

  3. Close the endgate and inspect for proper fit and operation.
  4. Adjust the endgate, if required. Refer to Hinge Replacement - Endgate .
scientia non olet · About LEMON Manuals