LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (Body Rear End) >> Repair Instructions >> Lock Cylinder Replacement - Endgate >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the endgate.
  2. Remove the endgate trim panel. Refer to Trim Panel Replacement - Endgate .
  3. Remove the endgate water deflector. Refer to Water Deflector Replacement - Endgate .
  4. Disconnect the electrical connector from the endgate lock cylinder.
    Fig 1: View Of Endgate Lock Cylinder Electrical Connector
    GM621902Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the endgate lock cylinder wiring harness from the endgate inner panel.
  6. Remove the endgate lock cylinder retainer from the lock cylinder.
    Fig 2: Identifying Endgate Lock Cylinder
    GM621888Courtesy of GENERAL MOTORS CORP.
  7. Remove the endgate lock cylinder from the endgate.
scientia non olet · About LEMON Manuals