LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (Body Rear End) >> Repair Instructions >> Lock Cylinder Replacement - Endgate >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the endgate lock cylinder to the endgate.
    2. Fig 1: Identifying Endgate Lock Cylinder
    GM621888Courtesy of GENERAL MOTORS CORP.
  2. Install the endgate lock cylinder retainer to the lock cylinder, pressing into place until fully seated.
  3. Connect the electrical connector to the endgate lock cylinder.
  4. Connect the endgate lock cylinder wiring harness to the endgate inner panel.
  5. Install the endgate water deflector. Refer to Water Deflector Replacement - Endgate .
  6. Install the endgate trim panel. Refer to Trim Panel Replacement - Endgate .
  7. Close the endgate.
scientia non olet · About LEMON Manuals