LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (Body Rear End) >> Repair Instructions >> Hinge Replacement - Liftgate (Aztek) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the liftgate. Refer to Liftgate Replacement (Rendezvous) .
  2. Mark the location of the liftgate hinges with a grease pencil.
  3. Remove the nuts from the liftgate hinges.
    IMPORTANT: Mark the location of the shims right and/or left for reinstallation.
  4. Remove the liftgate hinges with the shims and seals from the vehicle.
    Fig 1: Identifying Liftgate Hinge Shims & Seals (Aztek)
    GM743284Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals