LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (Body Rear End) >> Repair Instructions >> Hinge Replacement - Endgate >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the liftgate.
  2. Open the endgate.
  3. Disconnect the electrical harness from the endgate.
  4. Remove the bolts from the endgate hinge to endgate.
    Fig 1: Identifying Endgate Hinge Bolts
    GM743282Courtesy of GENERAL MOTORS CORP.
  5. Remove the endgate, with an assistant.
  6. Remove the endgate nuts from the endgate hinge.
    Fig 2: View Of Endgate
    GM743283Courtesy of GENERAL MOTORS CORP.
  7. Remove the endgate hinge from the rear body panel.
scientia non olet · About LEMON Manuals