LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (Body Rear End) >> Repair Instructions >> Fuel Filler Pocket Replacement (Rendezvous) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fuel filler pocket to the fuel filler neck, pressing into place until fully seated.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screws to the fuel filler pocket.

    Tighten:  Tighten the fuel filler pocket screw to 2 N.m (18 lb in).

    Fig 1: Locating Fuel Filler Pocket Retaining Screws (Rendezvous)
    GM754973Courtesy of GENERAL MOTORS CORP.
  3. Install the fuel filler neck seal to the fuel filler neck.
  4. Install the fuel filler cap to the fuel filler neck.
scientia non olet · About LEMON Manuals