LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1103 (Body Rear End) >> Repair Instructions >> Bellcrank Replacement - Endgate >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the endgate trim panel. Refer to Trim Panel Replacement - Endgate .
  2. Remove the endgate water deflector. Refer to Water Deflector Replacement - Endgate .
  3. Remove the endgate handle rod from the endgate bellcrank.
    Fig 1: Locating Endgate Latch Rod
    GM621893Courtesy of GENERAL MOTORS CORP.
  4. Remove the endgate latch rods from the endgate bellcrank.
  5. Remove the bolts from the bellcrank to the endgate.
    Fig 2: Identifying Endgate Bellcrank Mounting Bolts
    GM621892Courtesy of GENERAL MOTORS CORP.
  6. Remove the endgate bellcrank from the endgate.
    Fig 3: View Of Endgate Bellcrank
    GM621891Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals