LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1099 (Engine Controls - 3.4L - Introduction - Service & Replacement) >> Repair Instructions >> Fuel Level Sensor Replacement (VIN 4S558922 and Later (130mm Sender)) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fuel sender from the fuel tank. Refer to Fuel Sender Assembly Replacement (Prior to VIN 4S558922 (100mm Sender)) Fuel Sender Assembly Replacement (VIN 4S558922 and Later (130mm Sender))  Engine Controls - 3.6L (LY7).
    2. Fig 1: View Of Fuel Level Sensor Electrical Connector
    GM1404537Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the fuel level sensor electrical connector located in the module cover.
  3. Use a small flat-bladed tool in order to disengage the fuel level sensor retainer.
    4. Fig 2: Aligning Fuel Level Sensor
    GM1404543Courtesy of GENERAL MOTORS CORP.
  4. Slide the fuel level sensor down in order to remove the fuel level sensor from the fuel sender module.
scientia non olet · About LEMON Manuals