LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1099 (Engine Controls - 3.4L - Introduction - Service & Replacement) >> Repair Instructions >> Filler Tube Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Fuel Filler Pipe Attaching Nut To Wheelhouse Stud
    GM670047Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Cover and Plug Openings Notice in Cautions and Notices.
    IMPORTANT: Always maintain cleanliness when servicing fuel system components.
  1. Relieve the fuel system pressure. Refer toFuel Pressure Relief Procedure .
  2. Remove the fuel filler cap.
  3. Drain the fuel tank. Refer to Fuel Tank Draining Procedure .
  4. Raise the vehicle. Refer toLifting and Jacking the Vehicle in General Information.
  5. Remove the fuel filler pipe attaching nut to wheelhouse stud (1).
  6. Remove the fuel filler pipe attaching screw (3) to the wheelhouse panel.
    7. Fig 2: View Of Fuel Tank Filler Pipe Hose Clamp
    GM670051Courtesy of GENERAL MOTORS CORP.
  7. Loosen the fuel filler pipe clamp.
  8. Remove the fuel filler pipe (2) from the fuel tank (1).
    9. Fig 3: Locating Fuel Filler Pipe Attaching Nut To Wheelhouse Stud
    GM670047Courtesy of GENERAL MOTORS CORP.
  9. Remove the fuel filler pipe from the grommet on the fuel filler pocket (4).
scientia non olet · About LEMON Manuals