LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1099 (Engine Controls - 3.4L - Introduction - Service & Replacement) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying EVAP Canister & Purge Pipe
    GM670190Courtesy of GENERAL MOTORS CORP.
  1. Slide the EVAP canister vent solenoid (2) on the EVAP canister vent bracket until the solenoid snaps into place.
  2. Connect the EVAP vent hose to the EVAP canister vent solenoid.
    3. Fig 2: Identifying Evaporative Emission (EVAP) Canister Vent Solenoid Harness Connector
    GM238422Courtesy of GENERAL MOTORS CORP.
  3. Connect the EVAP canister vent solenoid harness connector.
  4. Install the fuel tank. Refer to Fuel Tank Replacement (Prior to VIN 4S558922 (100mm Sender)) Fuel Tank Replacement (VIN 4S558922 and Later (130mm Sender)) .
scientia non olet · About LEMON Manuals