Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying EVAP Canister & Purge Pipe

Courtesy of GENERAL MOTORS CORP.

Install the EVAP canister (3) on the EVAP canister bracket.
Connect the EVAP hoses/pipes to the EVAP canister.

Fig 2: Locating EVAP Canister Bracket Retaining Nut

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Position the EVAP canister and bracket on the fuel tank and install the 2 retaining nuts.
Tighten: Tighten the retaining nuts to 10 N.m (89 lb in).
Install the fuel tank. Refer to Fuel Tank Replacement (Prior to VIN 4S558922 (100mm Sender)) Fuel Tank Replacement (VIN 4S558922 and Later (130mm Sender))