LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1099 (Engine Controls - 3.4L - Introduction - Service & Replacement) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Purge Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EVAP Canister Purge Valve
    GM576032Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Position the EVAP canister purge valve on the intake manifold and install the retainer bolt.

    Tighten:  Tighten the EVAP canister purge valve retaining bolt to 10 N.m (89 lb in).

    2. Fig 2: Connecting Vacuum Supply Hose To The EVAP Canister Purge Valve
    GM669537Courtesy of GENERAL MOTORS CORP.
  2. Connect the EVAP canister purge pipe and the vacuum supply hose.
  3. Connect the EVAP canister purge valve electrical connector.
scientia non olet · About LEMON Manuals