LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1099 (Engine Controls - 3.4L - Introduction - Service & Replacement) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement (24X CKP Sensor) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying CKP Sensor
    GM14714Courtesy of GENERAL MOTORS CORP.
  1. Install the 24X crankshaft position sensor (1) with bolts (4) and the route harness as noted during removal.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the harness retaining clip (3) with the bolt (4).

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  3. Connect the sensor electrical connector.
  4. Install the balancer on the crankshaft. Refer to Crankshaft Balancer Replacement in Engine Mechanical.
  5. Lower vehicle.
  6. Perform the CKP System Variation Learn Procedure. Refer to CKP System Variation Learn Procedure .
scientia non olet · About LEMON Manuals