Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Tilt Lever

Courtesy of GENERAL MOTORS CORP.

Install the tilt lever.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the retaining bolt to the tilt lever.
Tighten: Tighten the bolt to 10 N.m (89 lb in).
Install the tilt lever spring.
Install the lower trim cover. Refer to Steering Column Trim Covers Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.