LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1098 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Wheel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
  2. Remove the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement (Aztek) or Inflatable Restraint Steering Wheel Module Replacement (Rendezvous) in SIR.
  3. Disconnect the steering wheel control electrical connector.
  4. Remove the steering wheel nut.
  5. Install J 42578  and J 1859-A  to the steering wheel. See Special Tools and Equipment .
    6. Fig 1: Removing Steering Wheel
    GM255213Courtesy of GENERAL MOTORS CORP.
  6. Use J 42578  and J 1859-A  in order to remove the steering wheel. See Special Tools and Equipment .
  7. Remove J 42578  and J 1859-A  from the steering wheel. See Special Tools and Equipment .
  8. Remove the controls and the control harness from the steering wheel.
scientia non olet · About LEMON Manuals