LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1098 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Wheel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the controls and the control harness to the steering wheel.
    2. Fig 1: Steering Wheel, Shaft & Nut
    GM294367Courtesy of GENERAL MOTORS CORP.
  2. Install the wiring through the steering wheel.
  3. Install the steering wheel.
  4. Connect the steering wheel control electrical connector.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the steering wheel nut.

    Tighten:  Tighten the nut to 41 N.m (30 lb ft).

  6. Install the inflator module. Refer to Inflatable Restraint Steering Wheel Module Replacement (Aztek) or Inflatable Restraint Steering Wheel Module Replacement (Rendezvous) in SIR.
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 .
scientia non olet · About LEMON Manuals