LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1098 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Wheel Control Switch Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR System. Refer to SIR Disabling and Enabling Zone 3 in SIR.
    2. Fig 1: Identifying Steering Wheel Rear Bezel Retaining Screws
    GM691015Courtesy of GENERAL MOTORS CORP.
  2. Remove the steering wheel. Refer to Steering Wheel Replacement .
  3. Remove the retaining screws (2, 3) from the steering wheel rear bezel.
  4. Remove the steering wheel rear bezel (1).
    5. Fig 2: View Of Inner Steering Wheel Connector
    GM691024Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connector.
  6. Insert a small, blunt-ended tool into the access hole in the back of the steering wheel. Push the switch out of the steering wheel.
scientia non olet · About LEMON Manuals