LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1098 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Wheel Control Switch Assembly Replacement >> Installation procedure

Installation procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Inner Steering Wheel Connector
    GM691024Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connector.
  2. Align the switch to the opening in the steering wheel.
  3. Push the switch into the steering wheel.
    4. Fig 2: Identifying Steering Wheel Rear Bezel Retaining Screws
    GM691015Courtesy of GENERAL MOTORS CORP.
  4. Install the steering wheel rear bezel (1).
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the retaining screws (2, 3) to the steering wheel rear bezel.

    Tighten:  Tighten the screws to 3 N.m (27 lb in).

  6. Install the steering wheel. Refer to Steering Wheel Replacement .
  7. Enable the SIR System. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals