LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1098 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Column Anchor Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Properly route the steering column anchor cable.
    2. Fig 1: View Of Anchor Cable Nut On Center Console Bracket
    GM545578Courtesy of GENERAL MOTORS CORP.
  2. Install the anchor cable to the center console bracket stud.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the anchor cable nut to the center console bracket stud.

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

  4. Install the steering column anchor cable end to the steering column stud.
    5. Fig 2: Identifying Steering Column Upper Nut
    GM545583Courtesy of GENERAL MOTORS CORP.
  5. Install the steering column nut. Refer to Steering Column Replacement .
  6. Install the center console. Refer to Console Replacement - Front Floor (Aztek) or Console Replacement - Front Floor (Rendezvous) in Instrument Panel, Gages and Console.
  7. Install the knee bolster. Refer to Knee Bolster Replacement in Instrument Panel, Gages and Console.
scientia non olet · About LEMON Manuals