Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Connect the electrical connector to the ignition switch.

Fig 1: View of Ignition Cylinder Lock, Ignition Lock Cylinder Case Assembly and Upper Steering Column

Courtesy of GENERAL MOTORS CORP.

Slide the ignition switch into the ignition lock cylinder case.

Fig 2: Locating Theft Deterrent Control Module

Courtesy of GENERAL MOTORS CORP.

Push the theft deterrent module (2), onto the lock cylinder housing (1).
Install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
Enable the SIR System. Refer to SIR Disabling and Enabling Zone 3 in SIR.