Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Refer to Gasoline/Gasoline Vapors Caution in Cautions and Notices.

Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure .

CAUTION: Wear safety glasses when using compressed air, as flying dirt particles may cause eye injury.

Fig 1: Blowing Dirt Out Of Fitting (Plastic Collar)

Courtesy of GENERAL MOTORS CORP.

Blow dirt out of the fitting using compressed air.

Fig 2: Squeezing Quick Connect Fitting Release Tabs (Plastic Collar)

Courtesy of GENERAL MOTORS CORP.

Squeeze the plastic tabs of the male end connector.

Fig 3: Pulling Connection Apart (Plastic Collar)

Courtesy of GENERAL MOTORS CORP.

Pull the connection apart.
Using a clean shop towel, wipe off the male pipe end
Inspect both ends of the fitting for dirt and burrs.
Clean or replace the components as required.