Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak.
During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection if not lubricated.

Fig 1: Lubricating Male Pipe End

Courtesy of GENERAL MOTORS CORP.

Apply a few drops of clean engine oil to the male pipe end.

Fig 2: Connecting Fittings (Plastic Collar)

Courtesy of GENERAL MOTORS CORP.

Push both sides of the quick-connect fitting together to cause the retaining tabs/fingers to snap into place.

Fig 3: Ensuring Secure Connection

Courtesy of GENERAL MOTORS CORP.

Pull on both sides of the quick-connect fitting to make sure the connection is secure.
Inspect for leaks using the following procedure:
1. Turn the ignition ON, with the engine OFF for 2 seconds.
2. Turn the ignition OFF, for 10 seconds.
3. Turn the ignition ON, with the engine OFF for 2 seconds.
4. Turn the ignition OFF.
5. Inspect for leaks.