Removal Procedure
WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure .
- Remove the retainer from the quick-connect fitting.
- Use compressed air in order to remove any debris from the fitting.
- Use Snap-On® ACT1370 Disconnect Set or equivalent in order to disconnect the fuel line.
- Using a clean shop towel, wipe off the male pipe end.
- Inspect both ends of the fitting for dirt and burrs.
- Clean or replace the components as required.
CAUTION:
Refer to Gasoline/Gasoline Vapors Caution
in Cautions and Notices.
CAUTION:
Wear safety glasses when using compressed air, as flying dirt particles may cause eye injury.
NOTE:
If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end in order to prevent damage to the O-ring sealing surface. Use a clean shop towel in order to wipe off the male tube ends. Inspect all the connections for dirt and burrs. Clean or replace the components and assemblies as required.