LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1097 (Engine Controls - 3.6L (Ly7) (Introduction)) >> Repair Instructions >> Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Mass Air Flow (MAF)/Intake Air Temperature (IAT) Sensor
    GM1395972Courtesy of GENERAL MOTORS CORP.
  1. Turn the ignition OFF.
  2. Remove the mass air flow (MAF) electrical connector.
  3. Remove the air cleaner intake duct. Refer to Air Cleaner Intake Duct Replacement .
  4. Remove the MAF sensor screws.
  5. Remove the MAF sensor and the MAF sensor seal.
scientia non olet · About LEMON Manuals