LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1097 (Engine Controls - 3.6L (Ly7) (Introduction)) >> Repair Instructions >> Ignition Coil(s) Replacement - Bank 1 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Ignition Coil View
    GM860797Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coils.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the ignition coil bolts.

    Tighten:  Tighten the ignition coil bolts to 10 N.m (89 lb in).

    3. Fig 2: Locating Ignition Coil Electrical Connectors
    GM1394028Courtesy of GENERAL MOTORS CORP.
  3. Connect the ignition coil electrical connectors.
    4. Fig 3: Supporting Powertrain With A Floor Jack
    GM628909Courtesy of GENERAL MOTORS CORP.
  4. Use the floor jack in order to raise the powertrain until the frame contacts the chassis.
  5. Install the frame front bolts. Refer to Frame Replacement - Front (W/AWD) or Frame Replacement - Front (W/FWD) in Frame and Underbody.
  6. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  7. Install the front fender liners. Refer to Front Fender Liner Replacement in Body Front End.
  8. Connect the intermediate steering shaft to the steering gear. Refer to Intermediate Steering Shaft Replacement in Steering Wheel and Column.
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals