LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1097 (Engine Controls - 3.6L (Ly7) (Introduction)) >> Repair Instructions >> Fuel Pressure Gage Installation and Removal >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Relieve the fuel pressure. Refer to Fuel Pressure Relief Procedure .
    2. CAUTION: Wrap a shop towel around the fuel pressure connection in order to reduce the risk of fire and personal injury. The towel will absorb any fuel leakage that occurs during the connection of the fuel pressure gage. Place the towel in an approved container when the connection of the fuel pressure gage is complete.
  2. Remove the fuel pressure gage.
  3. Place the shop towel in an approved container.
  4. Install the fuel pressure test port cap.
scientia non olet · About LEMON Manuals