LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1097 (Engine Controls - 3.6L (Ly7) (Introduction)) >> Repair Instructions >> Camshaft Position (CMP) Actuator Solenoid Replacement - Bank 2 (Left) Exhaust >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition OFF.
    2. IMPORTANT: Do not disconnect the power steering fluid lines/hoses from the reservoir.
  2. Remove the power steering fluid reservoir bolts and reposition the power steering fluid reservoir in order to provide access. Refer to Remote Power Steering Fluid Reservoir Replacement (LY7) in Power Steering System.
    3. Fig 1: View Of Camshaft Position (CMP) Actuator Valve Electrical Connector
    GM1394071Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the camshaft position (CMP) actuator valve electrical connector (2).
    4. Fig 2: Locating CMP Actuator Valve Bolt
    GM1395980Courtesy of GENERAL MOTORS CORP.
  4. Remove the CMP actuator valve bolt.
  5. Remove the CMP actuator valve.
scientia non olet · About LEMON Manuals