LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1097 (Engine Controls - 3.6L (Ly7) (Introduction)) >> Repair Instructions >> Air Cleaner Intake Duct Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Intake Air Duct
    GM1404636Courtesy of GENERAL MOTORS CORP.
  1. Install the air intake duct to the MAF sensor.
  2. Install the air cleaner intake duct to the throttle body.
  3. Connect the PCV tube to the air intake duct.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Tighten the air intake air duct clamps.

    Tighten:  Tighten the clamps to 2 N.m (18 lb in).

scientia non olet · About LEMON Manuals