LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1093 (Antilock Brake System And Traction Control System) >> Repair Instructions >> Wheel Speed Sensor Replacement - Rear (Rear (w/AWD)) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wheel bearing/hub.
    2. CAUTION: These fasteners MUST be replaced with new fasteners anytime they become loose or are removed. Failure to replace these fasteners after they become loose or are removed may cause loss of vehicle control and personal injury.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the NEW wheel bearing/hub bolts.

    Tighten:  Tighten the NEW wheel bearing/hub bolts to 85 N.m (63 lb ft).

  3. Connect the drive axle to the wheel bearing/hub. Refer to Wheel Drive Shaft Replacement - Rear in Wheel Drive Shafts.
  4. Install the wheel speed sensor electrical connector to the connector bracket.
    5. Fig 1: Locating Wheel Speed Sensor Electrical Connector
    GM629522Courtesy of GENERAL MOTORS CORP.
  5. Connect the wheel speed sensor electrical connector.
  6. Install the brake rotor.
  7. Install the brake caliper bracket. Refer to Brake Caliper Bracket Replacement - Rear in Disc Brakes.
  8. Install the brake caliper. Refer to Brake Rotor Replacement - Rear in Disc Brakes.
  9. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals