LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1093 (Antilock Brake System And Traction Control System) >> Repair Instructions >> Wheel Speed Sensor Jumper Harness Replacement - Rear >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Rear Wheel Speed Sensor Jumper Harness Retaining Clips
    GM230413Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle on a suitable hoist. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the rear wheel speed jumper harness connector at the pass thru connector.
  3. Remove the rear wheel speed sensor jumper harness (1) from the retaining clips (2).
    4. Fig 2: Rear Wheel Speed Sensors Component View
    GM305363Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the rear wheel speed sensor jumper harness connector (1) from the wheel speed sensor, located next to the rear strut (2).
  5. Remove the rear wheel speed sensor jumper harness.
scientia non olet · About LEMON Manuals