LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1093 (Antilock Brake System And Traction Control System) >> Repair Instructions >> Wheel Speed Sensor Jumper Harness Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Wheel Speed Sensors Component View
    GM305363Courtesy of GENERAL MOTORS CORP.
  1. Connect the rear wheel speed sensor jumper harness connector (1) to the wheel speed sensor, located next to the rear strut (2).
    2. Fig 2: Locating Rear Wheel Speed Sensor Jumper Harness Retaining Clips
    GM230413Courtesy of GENERAL MOTORS CORP.
  2. Install the rear wheel speed jumper harness (1) into the retaining clips (2).
  3. Connect the rear wheel speed sensor jumper harness connector to the pass thru connector.
  4. Lower the vehicle.
  5. Turn the ignition switch to the RUN position, with the engine off.
  6. Perform the diag system check. Refer to Diagnostic System Check - ABS .
scientia non olet · About LEMON Manuals