Cruise Control Indicator Inoperative (3.4L)
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Cruise Control Indicator Inoperative (3.4L)
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Cruise Control Schematics | |||
| 1 | Did you perform A Diagnostic System Check - Cruise Control? | Go to Step 2 | Go to Diagnostic System Check - Cruise Control (3.4L) or Diagnostic System Check - Cruise Control (3.6L) |
| 2 |
|
Go to Step 3 | Go to Step 4 |
| 3 | Inspect for poor connections at the harness connector of the powertrain control module (PCM). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 7 | Go to Step 5 |
| 4 | Inspect for poor connections at the harness connector of the instrument panel cluster (IPC). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 7 | Go to Step 6 |
| 5 |
IMPORTANT:
Replacement PCM must be programmed. Replace the PCM. Refer to Powertrain Control Module (PCM) Replacement
in Engine Controls-3.4L.Did you find and correct the condition? |
Go to Step 7 | - |
| 6 | Replace the IPC. Refer to Instrument Panel Cluster (IPC) Replacement
in Instrument Panel, Gages, and Console. Did you complete the repair? |
Go to Step 7 | - |
| 7 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |