Cruise Control Indicator Always On (3.6L)
WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
Cruise Control Indicator Always On (3.6L)
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Cruise Control Schematics Connector End View Reference: Cruise Control Connector End Views |
|||
| 1 | Did you perform the Cruise Control Diagnostic System Check? | Go to Step 2 | Go to Diagnostic System Check - Cruise Control (3.4L) or Diagnostic System Check - Cruise Control (3.6L) |
| 2 | Turn the ignition ON, with the engine OFF. Does the Cruise indicator illuminate after the instrument panel cluster (IPC) displays test? |
Go to Step 3 | Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems |
| 3 |
|
Go to Step 4 | Go to Step 5 |
| 4 |
IMPORTANT:
Program the replacement PCM. Replace the PCM. Refer to Engine Control Module (ECM) Replacement
in Engine Controls - 3.6L (LY7).Did you complete the replacement? |
Go to Step 6 | - |
| 5 | Replace the IPC. Refer to Instrument Panel Cluster (IPC) Replacement
in Instrument Panel, Gages, and Console. Did you complete the replacement? |
Go to Step 6 | - |
| 6 | Operate the system in order to verify the repair. Does the system operate properly? |
System OK | Go to Step 2 |