Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Lower Trim Plate Screws

Courtesy of GENERAL MOTORS CORP.

Align the retainers on the I/P accessory trim plate to the slots in the I/P.
Install the retainers into the slots until the retainers are fully seated.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the 2 screws to the lower trim plate.
Tighten: Tighten the screws to 2 N.m (18 lb in).
Install the front floor console. Refer to Trim Plate Replacement - Front Floor Console (Aztek) or Trim Plate Replacement - Front Floor Console (Rendezvous) .