Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Align the trim plate to the front floor console.
Position the trim plate over the transaxle shift lever.
Install the trim plate to the front floor console and snap into place.

Fig 1: View Of Front Floor Console Components

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the rear trim plate screw and insert the cup holder liner.
Tighten: Tighten the screw to 2 N.m (18 lb in).