LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1091 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Trim Plate Replacement - Console Rear (Rendezvous) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Console Trim Plate - Rear
    GM785443Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connections.
  2. Press the trim plate to the console until the plate is fully seated.
    3. Fig 2: View Of Console
    GM785524Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the trim plate screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  4. Close the armrest.
scientia non olet · About LEMON Manuals