LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1091 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Aztek) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the knee bolster panel. Refer to Knee Bolster Replacement .
    2. Fig 1: Locating I/P Cluster Trim Plate At Assist Handle Screws
    GM630754Courtesy of GENERAL MOTORS CORP.
  2. Remove the screws from the I/P cluster trim plate at the assist handle.
  3. Pull out the I/P cluster trim plate in order to release from the retainers.
    4. Fig 2: View Of Driver Information Center (DIC)
    GM634152Courtesy of GENERAL MOTORS CORP.
  4. From the back side disconnect the driver information center (DIC) from the I/P cluster trim plate panel.
  5. Loosen the steering column bracket and lower the steering column.
  6. Remove the I/P cluster trim plate.
scientia non olet · About LEMON Manuals