LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1091 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Aztek) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating I/P Cluster Trim Plate At Assist Handle Screws
    GM630754Courtesy of GENERAL MOTORS CORP.
  1. Align the I/P cluster trim plate to the instrument panel retainers.
    2. Fig 2: View Of Driver Information Center (DIC)
    GM634152Courtesy of GENERAL MOTORS CORP.
  2. Connect the DIC to the I/P cluster trim plate panel.
  3. Install the I/P cluster trim plate.

    Press into place until fully seated.

    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the screws to the I/P cluster trim plate at the assist handle.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  5. Install the knee bolster panel. Refer to Knee Bolster Replacement .
  6. Tighten the bolts which secure the steering column bracket.

    Tighten:  Tighten the bolts to 6 N.m (53 lb in).

scientia non olet · About LEMON Manuals