Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Insert the key into the lock cylinder.

Fig 1: Identifying I/P Compartment Door Lock Cylinder

Courtesy of GENERAL MOTORS CORP.

Align the lock cylinder in the same position used for removal. Push the cylinder in place to seat fully.
Turn the key counterclockwise to secure the lock cylinder retainer.
Remove the key from the lock cylinder.
Inspect the operation of the lock cylinder. The lock cylinder should only allow a 1/4 turn and should be securely retained in the door handle.
Align and install the I/P compartment handle to the I/P compartment. Refer to Handle Replacement - Instrument Panel (I/P) Compartment (Aztek) .
Close the I/P compartment door.