LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1091 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Knee Bolster Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Pontiac Aztek and 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Knee Bolster Assembly
    GM318206Courtesy of GENERAL MOTORS CORP.
  1. Perform the following steps in order to install the knee bolster to the instrument panel:
    1. Align the clips with the slots in the instrument panel.
    2. Push in, in order to secure the knee bolster.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts to the bottom of the knee bolster.

    Tighten:  Tighten the bolts/screws to 2.5 N.m (22 lb in).

  3. Install the IP insulator. Refer to Closeout/Insulator Panel Replacement - Right  and Closeout/Insulator Panel Replacement - Left .
scientia non olet · About LEMON Manuals